Once again, I decided I had better stop talking, and start doing. We have collected so many bottles at our place as we investigate options for recycling the 44 million PET bottles that are sold in Fiji each year. On the weekend, we made a cover for the outdoor fluorescent light out of recycled PET plastic bottles.
I had seen something similar on the internet, and decided to give it a try, as often these crafty ideas are not as easy as they appear, but this one was!
Here is what we did:
My friend Vuli came for a visit with two of her grandkids. It was her and I, plus 4 little boys as “helpers”, plus I had two boys with me. I was going to take photos of the process, but we got caught up trying to mind 4 boys with a soldering iron and stanley knives, so you get the picture.
I can make an instructional set of pictures if anyone is interested. The whole thing took about 2 hours in between making snacks for the kids and being a gopher for my husband while he and his father were doing some yard work, and Vuli and I secretly believe that we would have done it faster, and with a bit more of a polished result had we been “alone”. It was so fun though and the kids had a ball, plus do they really want long lectures on recycling, or just a taste of the action?
1 piece of chicken wire or other mesh as big as you need to hang below your fluorescent light (ours was about 25cm by 85cm)
- 12 or 14 plastic PET bottles any size
- stanley knife
- spray paint
- old wire (we used an old piece of electrical wire and pulled it apart)
- a couple of curtain rings if you are fancy
- a couple of screw in eyelets if you want to permanently attach it
- soldering iron or other hot poker type device to poke holes in the flowers to thread the wire through
- wash the bottles
- cut the bottles in half around the middle. We used the stanley knife just to make the first incision, and then used the scissors to cut around
- use the scissors and cut lots of little strips into the bottles to form the petals
- you can use a butter knife and pull the strips similar to the way you use curling ribbon, but we found the simplest thing for the kids was just to bend the petals back and kind of fold them for some kinks
- you can put two pieces one inside the other if you want a fuller flower, or just use one
- put on newspaper or an old mat and use any colours of spray paint to lightly spray each flower (we had black, gold and red)
- use the soldering iron or a heated up skewer to poke a hole in the base of each flower
- thread a piece of wire through the hole (or fishing line might be good)
- attach the wire to the chicken wire frame
- use one longer piece of wire at each end to make it hang, and put curtain ring on each so that you can hang up
- use two screw islets to hang from ceiling, or we just threaded some wire through the verandah.
- anyway, it looks really nice, and even the men like it. It gives the fluro light a softer glow somehow